Compound shutter repair manual

 · The service manual gives a 64 degree pitch for all versions of #3, 4 and 5 shutters' tubes' inner threads. The mount threads (rear tube outer threading) vary, but that doesn't bear on the OP's question. FYI, there's a link to the service manual in "the list" and post #3 above has directions for finding the list. Set to ‘B’, trip the shutter with a locking cable release, open the back, put the glass with the tape side towards the lens between the film guide rails, and check focus with a loupe. Now, to make real ground glass for TLRs here’s an easy way: go to the auto parts store and pick up a little $5 container of valve grinding compound. Olympus trip 35 1/ ths* manual shutter speed guide · for this operation we are going to need to remove the lens, shutter, viewfinder, metering system from the camera body. Don’ t be scared though, it is easy. I had no experience or repair manual and i .

All data are taken from the Compur Repair Manual, so they should be correct. There were five sizes of Compound shutter (late type, with X-sync): Compound 3-X Tube 7 Compound 4-X Tube 9 Compound 4-X Tube 10/II Compound 5-X Tube 12/I Compound 5-X Tube 12/II Dimensions are listed as: A: Cell thread (all are the same front and rear), all are 40 t.p.i. Compound Shutters. Compound #5. Compound shutters were manufactured by F Deckel of München from They use a compressed air piston to drive the shutter mechanism and feature speeds of up to 1/ of a second on some models. Some important specifications for Compound shutters are listed below. 5. Pull off the shutter assembly. 6. Replace the shutter assembly with the new one. 7. With the control turned fully clockwise, align the shutter in such a way that it does not cover the hole in the front panel. Replace the screw and tighten the screw until it holds the shutter in place and still allows for free movement of the shutter.

Bob can service any leaf shutter - from Copal to Seiko, he can always repair them to good working order and has a stock of parts. A CLA is usually required. The shutter only fires at one speed (1/50s?) and the little metal guide for the cable release is missing. The Z-M-B lever is said to be. 20 thg 6, After shutter has been fired. (1) Piston not visible inside the black cylinder. (1a) Spring providing pressure on the piston guide arm. (1b).